2018 EcoSport, ForScan, and new FDRS protocol

Car configuration discussions and experience sharing
Lemmi69
Posts: 4
Joined: Thu Dec 20, 2018 8:14 pm
Vehicle: Ford Ecosport 1l 140PS 2018

Re: 2018 EcoSport, ForScan, and new FDRS protocol

Post by Lemmi69 » Mon Dec 31, 2018 9:49 am

I have a question.
Does anyone have a screenshot of the APIM with camera, or can someone tell me what value I have to change?
Have the sync3 with software 3.3 and 8 "monitor.

villo
Posts: 4
Joined: Sat Mar 31, 2018 4:15 pm
Vehicle: Ecosport TiVCT 1.5 Dragon 123CV, 2017

Re: 2018 EcoSport, ForScan, and new FDRS protocol

Post by villo » Mon Jan 07, 2019 7:39 pm

7D0-01-01 x*xx xxxx xxxx Reverse camera (8" screen only): 0=disabled, 2=enabled, A=enabled with obstacle detection

I have an A on my 2018 Ford Ecosport Titanium.

Lemmi69
Posts: 4
Joined: Thu Dec 20, 2018 8:14 pm
Vehicle: Ford Ecosport 1l 140PS 2018

Re: 2018 EcoSport, ForScan, and new FDRS protocol

Post by Lemmi69 » Mon Jan 14, 2019 6:26 am

Thank you

adrianopery
Posts: 6
Joined: Sat May 19, 2018 12:27 am
Vehicle: Ford Ecosport 2018

Re: 2018 EcoSport, ForScan, and new FDRS protocol

Post by adrianopery » Sun Mar 10, 2019 11:27 pm

Baby42 wrote:
Tue Dec 11, 2018 10:46 pm
Hello everyone
I added the icon tab in the sync 3 of the 2018 ecosport
It works great, the only "problem" I'm facing now is that the configuration is for the dual zone climate control but my car comes equipped with single zone so I'll try to change that later.
If anyone has any suggestions on how to do it I'd really appreciate.
Thanks
Hi Baby42, I did the same config and have the same situation.
I tried to change to single zone but when I insert the code 7 on the line 7D0-01-01, second block, last digit but when I press "Write", nothing changes.
If you discover how to change it, please, share with me.

Post Reply