P244d on 2010 Ford Focus 1.6tdci wont clear

Any issues related to FORScan application
Post Reply
jimridley
Posts: 2
Joined: Tue Aug 07, 2018 3:24 pm
Vehicle: ford focus 1.6tdci 2010

P244d on 2010 Ford Focus 1.6tdci wont clear

Post by jimridley » Fri Aug 10, 2018 11:12 am

Good afternoon

looking for some help on this code ,it says Catalyst temp too high during regeneration Bank 1 ,the code wont clear , I have fitted a new temp sensor in Bank 1 ,but its the same

went to the service procedures Reset the Exhaust gas temperature leaned values ,it says this is the only way to clear the code , & this starts ,but at 1percent it fails saying the procedure has been interupted (I don't touch anything )

can anybody help me get rid of this code

Thank you

Jim

Post Reply