Problem with Viaken ELM327 v3 FORD USB on chip STN1170

Discussion about adapters and connections - usage, problems, solutions
Post Reply
Canito
Posts: 1
Joined: Tue May 15, 2018 3:35 pm
Vehicle: Ford Fiesta, 1.5TDCI, 2013

Problem with Viaken ELM327 v3 FORD USB on chip STN1170

Post by Canito » Wed May 16, 2018 8:05 am

Hello, I have problem with interface ELM327 v3 FORD MSCAN HSCAN - Interfejs Vscan STN1170 USB fro Viaken.
He reads DTS codes, but when I want to change car configuration in Configuration and Programming section, the message appears "This interface has problems with compability with CAN Bus, It will be work in Read Only Mode".
So I have a question- is this interface can edit car configuration and what are his correct settings to do this?
I have Ford Fiesta 1.5 TDCI 2013.
Thanks for your help.

bobek
Posts: 1
Joined: Thu May 17, 2018 10:32 am
Vehicle: Ford Mondeo MK3

Re: Problem with Viaken ELM327 v3 FORD USB on chip STN1170

Post by bobek » Thu May 17, 2018 6:24 pm

HELL DOES NOT HAVE A PROBLEM WITH OBD2 INTERFACE ELM327 V4 VSCAN STN2120 USB AND DOES NOT CAUSE MESSAGE DIAGNOSTIC AND PROGRAMMING

Post Reply