Ford Edge dash lights up-tach & speedo dead

Share your FORScan experience with other users
Post Reply
mrpc9886
Posts: 2
Joined: Sun Jun 09, 2019 12:49 am
Vehicle: Ford Edge, 3.5l, 285hp, 2014

Ford Edge dash lights up-tach & speedo dead

Post by mrpc9886 » Sat Oct 12, 2019 1:20 am

Like it says, the 2014 80,000 mile Ford Edge SE starts normally, but then the warning lights and chimes come on one by one - TRAC, ABS, Charging System, TPMS and the speedo and tach die. According to FORSCAN all the modules DTC report "loss of communications"-

My question is- "where's the root cause?" PCM issue? Elsewhere? Tips on troubleshooting welcome!

here's the DTC codes logged:

===PCM DTC P160A:00-2F=== (NOTE: no programming changes made- no different sized tires- nada)
Code: P160A - Control Module Vehicle Options Reconfiguration Error

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module
===END PCM===

===OBDII DTC ===
Successful DTC reading, no error codes found

Module: On Board Diagnostic II
===END OBDII===

===FCIM DTC ===
Successful DTC reading, no error codes found

Module: Front Controls Interface Module
===END FCIM===

===FCDIM DTC ===
Successful DTC reading, no error codes found

Module: Front Control/Display Interface Module
===END FCDIM===

===FLM DTC ===
Successful DTC reading, no error codes found

Module: Front Lighting Control Module
===END FLM===

===OCS DTC U0100:00-08===
Code: U0100 - Lost Communication With ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Occupant Classification System Module
===END OCS===

===ABS DTC U0151:00-20===
Code: U0151 - Lost Communication With Restraints Control Module

Status:
- Malfunction Indicator Lamp is Off for this DTC

Module: Antilock braking system
===END ABS===

===ABS DTC U0212:00-28===
Code: U0212 - Lost Communication With Steering Column Control Module

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Antilock braking system
===END ABS===

===ABS DTC U0001:88-28===
Code: U0001 - High Speed CAN Communication Bus

Additional Fault Symptom:
- Bus Off

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Antilock braking system
===END ABS===

===ABS DTC C0040:64-68===
Code: C0040 - Brake Pedal Switch A

Additional Fault Symptom:
- Signal Plausibility Failure

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Antilock braking system
===END ABS===

===ABS DTC U0100:00-28===
Code: U0100 - Lost Communication With ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Antilock braking system
===END ABS===

===ABS DTC U0140:00-68===
Code: U0140 - Lost Communication With Body Control Module

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
- Test not complete

Module: Antilock braking system
===END ABS===

===RCM DTC U0140:00-08===
Code: U0140 - Lost Communication With Body Control Module

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Restraint Control Module
===END RCM===

===RCM DTC B00A0:68-08===
Code: B00A0 - Occupant Classification System

Additional Fault Symptom:
- Event Information

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Restraint Control Module
===END RCM===

===RCM DTC U0028:08-08===
Code: U0028 - Vehicle Communication Bus A

Additional Fault Symptom:
- Bus Signal/Message Failures

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Restraint Control Module
===END RCM===

===ACM DTC U0256:00-08===
Code: U0256 - Lost Communication With Front Controls Interface Module A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Audio Control Module
===END ACM===

===BdyCM DTC U0100:00-08===
Code: U0100 - Lost Communication With ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Body Control Module
===END BdyCM===

===SCCM DTC ===
Successful DTC reading, no error codes found

Module: Steering Column Control Module
===END SCCM===

===IPC DTC P1706:62-2C===
Code: P1706 - High Vehicle Speed Observed in Park

Additional Fault Symptom:
- Signal Compare Failure

Status:
- DTC Maturing - Intermittent at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module
===END IPC===

===IPC DTC U0100:00-28===
Code: U0100 - Lost Communication With ECM/PCM A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module
===END IPC===

===IPC DTC U0121:00-28===
Code: U0121 - Lost Communication With Anti-Lock Brake System (ABS) Control Module A

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module
===END IPC===

===IPC DTC U0140:00-2E===
Code: U0140 - Lost Communication With Body Control Module

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module
===END IPC===

===IPC DTC U0424:00-2F===
Code: U0424 - Invalid Data Received From HVAC Control Module

Status:
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Instrument Panel Control Module
===END IPC===

===RTM DTC ===
Successful DTC reading, no error codes found

Module: Radio Transceiver Module
===END RTM===

===HVAC DTC U0140:00-08===
Code: U0140 - Lost Communication With Body Control Module

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Heating Ventilation Air Conditioning
===END HVAC===

===HVAC DTC U0401:82-08===
Code: U0401 - Invalid Data Received from ECM/PCM A

Additional Fault Symptom:
- Alive/Sequence Counter Incorrect/Not Updated

Status:
- Previously Set DTC - Not Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC

Module: Heating Ventilation Air Conditioning
===END HVAC===

denbo
Posts: 563
Joined: Mon Feb 06, 2017 3:00 pm
Vehicle: ford focus 16 zetec

Re: Ford Edge dash lights up-tach & speedo dead

Post by denbo » Sat Oct 12, 2019 8:35 am

The easiest way i can think of, is can you borrow dash from other/same vehicle. Plug it in and see. You may not be able to start vehicle, but it would prove the point. If you find its your dash, there are plenty of companies out there that do repairs.

Post Reply