2012 focus traction control

Share your FORScan experience with other users
Post Reply
catfish
Posts: 3
Joined: Fri Dec 12, 2014 1:36 pm
Vehicle: 2012 ford focus 2.0l

2012 focus traction control

Post by catfish » Fri Dec 12, 2014 1:40 pm

Are there any plans to include an option to disable traction control? I have an S model so I don't have the buttons and display that other models have to allow me to do this. Since other FF models allow this I don't think it should be a problem.

Thanks

FORScan
Site Admin
Posts: 2616
Joined: Fri Jun 13, 2014 2:21 am

Re: 2012 focus traction control

Post by FORScan » Sat Dec 13, 2014 10:00 am

You are probably right, but at this moment there is no such option available, and we also have no information on how to do it using a scantool.

catfish
Posts: 3
Joined: Fri Dec 12, 2014 1:36 pm
Vehicle: 2012 ford focus 2.0l

Re: 2012 focus traction control

Post by catfish » Sat Dec 13, 2014 12:41 pm

if you do find a method, there are lots of other folks looking for a something to do this and would be interested. Could you monitor the can bus when a model with the controls deactivates it and repeat the same commands?

FORScan
Site Admin
Posts: 2616
Joined: Fri Jun 13, 2014 2:21 am

Re: 2012 focus traction control

Post by FORScan » Tue Dec 16, 2014 8:18 am

FORScan uses special diagnostic protocols. It doesn't try to use or analyse internal communication protocols between modules. So if such a function provided by a module, it can be done (principially). Otherwise, it can not be done.

Abyway, we will keep this request in mind.

Post Reply