Page 1 of 1

P244d on 2010 Ford Focus 1.6tdci wont clear

Posted: Fri Aug 10, 2018 11:12 am
by jimridley
Good afternoon

looking for some help on this code ,it says Catalyst temp too high during regeneration Bank 1 ,the code wont clear , I have fitted a new temp sensor in Bank 1 ,but its the same

went to the service procedures Reset the Exhaust gas temperature leaned values ,it says this is the only way to clear the code , & this starts ,but at 1percent it fails saying the procedure has been interupted (I don't touch anything )

can anybody help me get rid of this code

Thank you