I'm new and need help.

Any issues related to FORScan application
Post Reply
temerick
Posts: 2
Joined: Sat Jun 24, 2017 1:37 pm
Vehicle: 2017 Ford Super Duty, 6.7L Powerstroke Diesel

I'm new and need help.

Post by temerick » Wed Jun 28, 2017 5:14 pm

Hello, i got everything connected and working properly this morning and started trying to make a few program changes. the problem was everytime I tried to write the new program it would not complete and said service procedure interupted. I can't find what i am doing wrong. i Did see on a few posts that maybe I need to update to the .10 version but i'm not sure where to go to do so. Any assistance would be greatly appreciated.

temerick
Posts: 2
Joined: Sat Jun 24, 2017 1:37 pm
Vehicle: 2017 Ford Super Duty, 6.7L Powerstroke Diesel

Re: I'm new and need help.

Post by temerick » Wed Jun 28, 2017 5:54 pm

I'm all set. UPdating the software did the trick.

korn_kid_12
Posts: 6
Joined: Sun Mar 18, 2018 5:58 pm
Vehicle: 2010 ford f150 5.4 4x4

Re: I'm new and need help.

Post by korn_kid_12 » Sun May 13, 2018 1:24 pm

I am getting this same error on a 2016 ford f250 6.7L Powerstroke. I am on forscan .14, but I have tried .13 also. I am trying to run the relearn procedure on the TCM after a tire size change. The BCM completes successfully. If anyone can help I would greatly appreciative since I have an appointment to drop it off with the dealer tomorrow for a coolant leak.
Attachments
error.PNG
error.PNG (110.61 KiB) Viewed 1609 times

martin123
Posts: 29
Joined: Wed Jul 15, 2015 5:24 pm
Vehicle: transit connect 2003 1.8 tddi

Re: I'm new and need help.

Post by martin123 » Fri May 18, 2018 7:26 pm

Ask dealers to do it while cars there no? Not going to cost extra

korn_kid_12
Posts: 6
Joined: Sun Mar 18, 2018 5:58 pm
Vehicle: 2010 ford f150 5.4 4x4

Re: I'm new and need help.

Post by korn_kid_12 » Sun May 27, 2018 5:37 pm

Dealer said they can't write new tire sizes on these trucks. Was to scared to bring it to them for a warranty repair with CEL on.

Tshoerichs
Posts: 2
Joined: Fri Jun 01, 2018 10:30 am
Vehicle: Ford, F150 Crew, 5.4l, 2009

Re: I'm new and need help.

Post by Tshoerichs » Tue Jun 05, 2018 11:02 am

I have a bbfly adapter that has a switch for the canbus speeds, if the switch is not set correctly, I get that error message. Not sure if your obdc adapter has a switch or not.

Post Reply