Page 14 of 14

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Thu Oct 08, 2020 6:38 pm
by Ford_Tech
I too have the VCM2 and cannot use it due to the firmware difference between bosch’s latest firmware and Ford’s integrated diagnostic software(IDS). After I downloaded bosch’s latest firmware from their website,I wasn’t able to use IDS anymore until I backdated the firmware to the version that IDS is programmed to use. I’ve also got a USB-Link™ 2: Bluetooth Edition, Autoenginuity SP03, IC4COM, & Nav-Link that I’ve yet to try. Does anybody know if any of these others work with Forscan?

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Sat Oct 17, 2020 11:29 am
by JNEDBM
Hi all,

I'm using a PEAK PCAN-USB adapter with up-to-date passthru driver. Can high and low are connected to HS can bus of Ford Mondeo 2001+.

J2534 adapter is found in ForScan (Adapter: PCANPT32) but it does not connect to vehicle (no communication, check that ignition is on).

Any ideas how to get that working?

Best regards!

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Wed Oct 21, 2020 6:24 am
by bijulal37
I have cardaq plus 2, that works excellent.Thanks for software creators.

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Fri Dec 04, 2020 6:22 pm
by Csubakka
Hi,

Anybody has tried genuine VAS 5054A with FORScan?

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Mon Jan 04, 2021 1:23 am
by amr1999
Hi i have jdiag elite pro support j2534-1 and j2534-2 but it cant read ms-can ecu any idea to solve it and thank you

Re: Support of J2534 (Pass-Thru) adapters in FORScan v2.2.*

Posted: Mon Jan 04, 2021 10:45 am
by achiko0077
Which OBD port would you recommend?