elm v1.4 ?

Discussion about adapters and connections - usage, problems, solutions
Post Reply
peko
Posts: 6
Joined: Mon Feb 20, 2017 5:56 pm
Vehicle: mazda 3 1L6 hdi 2004

elm v1.4 ?

Post by peko » Tue Feb 21, 2017 2:50 pm

hi friends

i test connect my elm327 v1.4 but without succes
so elm327 v1.4 is compatible ?

check error in screens

Image

Image

Image


thanks for your help ;)

SoNic67
Posts: 13
Joined: Sun May 31, 2015 8:44 pm
Vehicle: Mercury Sable, 3.0L DOHC, 2001

Re: elm v1.4 ?

Post by SoNic67 » Tue Feb 21, 2017 6:40 pm

I had the same surprise that the newest adapters (V1.5) don't have the Ford (or GM) protocols, they work only on Hyundai/Kia (ISO protocol). Maybe your is another "China special", Ford is using extra pins in the connector too, compared with ISO: https://en.wikipedia.org/wiki/On-board_ ... _connector
Last edited by SoNic67 on Tue Feb 21, 2017 6:47 pm, edited 1 time in total.

peko
Posts: 6
Joined: Mon Feb 20, 2017 5:56 pm
Vehicle: mazda 3 1L6 hdi 2004

Re: elm v1.4 ?

Post by peko » Tue Feb 21, 2017 6:45 pm

yes i open it and see nothing in OBD socket relative to CAN :o

SoNic67
Posts: 13
Joined: Sun May 31, 2015 8:44 pm
Vehicle: Mercury Sable, 3.0L DOHC, 2001

Re: elm v1.4 ?

Post by SoNic67 » Tue Feb 21, 2017 6:53 pm

Image

Do you have anything on the blue marked pins? Those are for SAE communication (Ford/Mazda). The ISO uses the yellow ones.
I didn't expect to have anything on the CAN ones (green).

peko
Posts: 6
Joined: Mon Feb 20, 2017 5:56 pm
Vehicle: mazda 3 1L6 hdi 2004

Re: elm v1.4 ?

Post by peko » Tue Feb 21, 2017 8:00 pm

nithing in pin 7 and pin 15

Post Reply