Beginner here. PCM Error / BCM Left low beam Malfunction

Discussion about adapters and connections - usage, problems, solutions
Post Reply
FunkerTactical
Posts: 1
Joined: Mon Oct 07, 2019 11:41 am
Vehicle: Ford Ranger 2019, Doratorque

Beginner here. PCM Error / BCM Left low beam Malfunction

Post by FunkerTactical » Sun Oct 27, 2019 9:29 am

Hello everyone. I had ELM WiFi & OBDLinkMX+. My 1st question is some car I can connect without any problem some I have issue like ERROR : “Unable to identify the vehicle - If PCM has a custom tune installed, please enter stategy/calibration name or part number of Factory PCM.” Where I can see PCM serial or number is there any web that I can use to identify such things?. 2nd question it regards to my FORD RANGER 2019 model I change the default light to HID I had this strange problem everytime I open the low beam it will shutdown automatically. Left only and after restarting it. It will work. I use forscan to check the error in BCM after clearing the code It is always returning after low beam don't work properly. Is there any fix for this one?. The code I'm pertaining written ground shortage. Already tried scanning the wirings 100% sure it is good. Kindly please advise me and help me. Thank you

Post Reply