Page 1 of 1

Backup Camera o Bad Wiring

Posted: Mon Mar 19, 2018 12:40 am
by MarioMatos
I Have Ford Explorer 2011 XLT
With My Ford Touch 3.10 (This Version No Have Option To Guideline)
1.jpg
1.jpg (281.8 KiB) Viewed 1006 times
My Ford Touch 3.08
Sin título.jpg
Sin título.jpg (48.59 KiB) Viewed 1006 times
Camera Working Without Guideline But Something Stop Working (BlackScreen) Only Need Put In N o P To Reverse And Working Again
2.jpg
2.jpg (196.77 KiB) Viewed 1006 times
3.jpg
3.jpg (157.88 KiB) Viewed 1006 times
Only Have One Code In BdyCM Module
4.jpg
4.jpg (95.03 KiB) Viewed 1006 times
Calibration Camera
5.jpg
5.jpg (128.73 KiB) Viewed 1006 times
Camera Work Again With Guideline And Zoom
6.jpg
6.jpg (63.46 KiB) Viewed 1006 times
After Few Mins Blackscreen And Dealer Message And Guideline Not Show (Put In N o P And Camera Show Again)
7.jpg
7.jpg (65.86 KiB) Viewed 1006 times
My Question Is.. I Have Bad Camera Or Something Else?

Re: Backup Camera o Bad Wiring

Posted: Wed Mar 21, 2018 11:39 pm
by MarioMatos
Bump

Re: Backup Camera o Bad Wiring

Posted: Thu Mar 22, 2018 11:14 pm
by TheLukeMartinez
Run selftest while concern is present. 9.5/10 with this concern is a bad camera. If you get a C1001:11, replace camera and retest for proper operation.