Page 1 of 1

2017 SuperDuty Problem

Posted: Thu Dec 21, 2017 11:41 pm
by wes57_02
I completed the following changes on my truck this afternoon:

Double Horn Honk Disable............BdyCM as built......726-41-02.....xxx1 xxxx xxxx.....xxx0 xxxx xxxx
Fog Lights with High Beam LED......BdyCM as built......726-27-01.....xxxx xxx1 xxxx.....xxxx xxx0 xxxx
Show Temps on Gauges...............IPC....................720-07-01.....xxxx xEA xxxx......xxxx x**x xxxx
Heated and Cooled Seats Icons......APIM..................7D0-01-01.....xxxx xxxx x4xx.....xxxx xxxx x*xx
Secure Idle (Police Mode).............BdyCM as built.....726-42-01......x0xx xxxx xxxx.....x1xx xxxx xxxx
Add DPF Filter % to screen............IPC...................720-07-02......x7xx xxxx ..........xFxx xxxx

For the DPF Filter % my original value was a 7 therefore I replaced it with the F per the notes section on the spreadsheet below:
https://docs.google.com/spreadsheets/d/ ... s/htmlview

I completed the key cycle, disconnected from the module after each program, and verified that the each program worked afterwards. The problem I am having is that my TPMS is not working now. Just shows dashes instead of the actual tire pressure. Has anyone had this problem or could refer me somewhere to look?

Thank you very much!

Re: 2017 SuperDuty Problem

Posted: Fri Dec 22, 2017 5:21 pm
by wes57_02
RESOLVED!

Re: 2017 SuperDuty Problem

Posted: Sat Dec 23, 2017 4:47 pm
by 2ndgnv82
What is supposed to go where the x's are

Re: 2017 SuperDuty Problem

Posted: Sat Dec 23, 2017 6:52 pm
by wes57_02
Nothing, the "x" value is used as place holders that you ignore.

Re: 2017 SuperDuty Problem

Posted: Wed Dec 26, 2018 1:11 am
by spectre127
What did you do to resolve this? Did the same changes as you did and having the same problem.

Re: 2017 SuperDuty Problem

Posted: Wed Dec 26, 2018 3:09 am
by wes57_02
Just drive it, it will fix itself.

Re: 2017 SuperDuty Problem

Posted: Sat Apr 13, 2019 9:49 pm
by MuleSkinner
wes57_02 wrote:
Fri Dec 22, 2017 5:21 pm
RESOLVED!
So? How was it resolved? NM - Read the rest of the thread :)

Re: 2017 SuperDuty Problem

Posted: Mon Jun 24, 2019 3:19 pm
by Demonrekon
just go drive it when programming it resets the saved data from previous drive cycle. which is what displays on the dash at first startup unless a tire is flat.