Hello! I am hoping to get a little help here resetting the ABS module.
I have a 1999 ford ranger that I put a carburated 5.0 into. I am attempting to use the computer to run the tach, speedometer, ABS, and a few other small things. I have the computer out of a 5.0 2000 ford explorer to properly run the tach. The truck was flooded when I first purchased it and I replaced the ABS module with another one out of the junkyard from another 99 Ranger. I keep getting code B2607= harness/configuration mismatched, I have been searching what to do for this for about a week and keep seeing I need the AS Build which does not seem to be correct. Anyone have any ideas as far as what I can do?
Thanks for your help.
Car configuration discussions and experience sharing
1 post • Page 1 of 1