2010 mazda 6 2.5 pats and programming key

Car configuration discussions and experience sharing
Post Reply
mrhappypantz
Posts: 14
Joined: Wed Nov 13, 2019 3:08 pm
Vehicle: Ford Edge, Gas , 2.0 turbo, 2012
Location: Fair Oaks ,Indiana

2010 mazda 6 2.5 pats and programming key

Post by mrhappypantz » Wed Nov 20, 2019 2:40 am

Hi, Newbie here, i just downloaded the forscan 2.3.26 beta and a extended license, i was hoping to program a 2nd ignition key (i only have one programmed key, i open forscan and connect to car using the elm327 v1.4 with toggle switch, i go to service tab and its only showing 5 or 6 modules and no pats as a option so i can try to program a key?? am i doing something incorrectly? shouldn't there be a lot of modules showing up? help???

mrhappypantz
Posts: 14
Joined: Wed Nov 13, 2019 3:08 pm
Vehicle: Ford Edge, Gas , 2.0 turbo, 2012
Location: Fair Oaks ,Indiana

Re: 2010 mazda 6 2.5 pats and programming key

Post by mrhappypantz » Sat Nov 23, 2019 1:28 am

Well so far the forum not much help to a newbie regarding mazda 6 key programming or even if i can use pats or if i have that option of getting into pats for key programming.

Post Reply