Sync 2 no Bass & Treble

Car configuration discussions and experience sharing
Post Reply
Posts: 1
Joined: Tue Oct 29, 2019 9:51 pm
Vehicle: 2014 Ford Taurus Limited 3.5

Sync 2 no Bass & Treble

Post by ytinfla » Fri Nov 08, 2019 5:40 pm

2014 Taurus Limited, had to replace the apim and I cannot get the bass and treble functions to appear, they are just greyed out, additionally I do not see a lot of functions listed when connected like turning off the double horn beep when engine is running, when connected its like I only see half of the items on the taurus spread sheet. Any ideas ?


Posts: 293
Joined: Sun Dec 03, 2017 3:04 am
Vehicle: 2003escapeltd
Location: eastern pennsylvania

Re: Sync 2 no Bass & Treble

Post by twisterrescue » Sat Nov 09, 2019 1:27 am

YOUR old screen driver needs reinstalled .read and save apim file .name file factory built .Then put your junk yard unit in car .go to configure & programming . pick apim then pick the run file . it will show the junk yard units file .pick load factory built file .then write . the unit seem,s to think car has sony system .yours must be base car ! Twister

Post Reply