Installed the backup camera in my 2015 F150 and made the changes to FCDIM and BCM modules. When i tried to run the LIN new mod calibration it stopped at 8%, followed the prompt to cycle off and and on and the process aborted with the log "Test aborted, perform a self test to identify any diagnostic trouble codes"
not sure if it is related but i also got a warning that the "steering lock power control - on"
Checked the DTC and got the following
Code: B115E - Camera Module
Additional Fault Symptom:
- Bus Signal/Message Failures
- DTC Present at Time of Request
- Malfunction Indicator Lamp is Off for this DTC
Module: Body Control Module
Car configuration discussions and experience sharing
1 post • Page 1 of 1