Search found 622 matches

by denbo
Thu May 03, 2018 6:42 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Transit 2005 2.4 DI - Non start after engine swap
Replies: 7
Views: 1443

Re: Transit 2005 2.4 DI - Non start after engine swap

Normally, when i have done an engine swap on these, i don,t change any thing. Just code key,s. By running the pats programme. I think you have really muddied the water,s now. The immo runs through other modules inc dash You could start by checking the identity and put everything back to stock. Then ...
by denbo
Wed May 02, 2018 6:07 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Injecter code configurations
Replies: 6
Views: 1635

Re: Injecter code configurations

If your going to take the filter off, which is likely just leave the sensors in and disconnect pipes/wires from other end. much easier.
by denbo
Tue May 01, 2018 5:37 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Injecter code configurations
Replies: 6
Views: 1635

Re: Injecter code configurations

You can,t do a regen if you have the mil on. As i don,t know the fault code or mileage i,m guessing its dpf is full. Get it off and cleaned,replace and reset. Better to do a running regen everytime. A static can burn the car down BEWARE.
by denbo
Mon Apr 30, 2018 5:41 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Injecter code configurations
Replies: 6
Views: 1635

Re: Injecter code configurations

No. Normally the cyl is as the firing order, 1342. So inj 2 = cyl3 etc etc
by denbo
Sun Apr 29, 2018 11:20 am
Forum: Diagnostics and Maintenance using FORScan
Topic: P003a-61
Replies: 9
Views: 1380

Re: P003a-61

you are correct.
by denbo
Sun Apr 29, 2018 11:18 am
Forum: Diagnostics and Maintenance using FORScan
Topic: Ford Focus CMAX, 2,0 CTDi, 2007
Replies: 5
Views: 1038

Re: Ford Focus CMAX, 2,0 CTDi, 2007

You must have battery support or charger connected. Do you have extended license?
by denbo
Wed Apr 25, 2018 5:44 pm
Forum: General and Support forum
Topic: Clearing DTCs Problem
Replies: 20
Views: 18344

Re: Clearing DTCs Problem

IDon,t think the android will do it
by denbo
Thu Apr 19, 2018 6:15 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: EGR/Pressure/Injector ? (P2458 Mazda 3 Y6)
Replies: 12
Views: 5113

Re: EGR Problem/Pressure/.. ? (P2458)

It looks like the ash content is high! Did you tell ecm the dpf was NEW.
by denbo
Wed Apr 18, 2018 5:40 pm
Forum: General and Support forum
Topic: focus 1.8 tdci 2008 bad starting no fault codes
Replies: 2
Views: 535

Re: focus 1.8 tdci 2008 bad starting no fault codes

Have the battery load tested first, then get the starter reconnd. Check the rpm while cranking, its important. While your at it, have the glow plugs tested.