Search found 16 matches

by Wod
Sat May 16, 2015 12:44 pm
Forum: General and Support forum
Topic: 1.6 Tdci glowplug control circuit p0380
Replies: 5
Views: 6333

Re: 1.6 Tdci glowplug control circuit p0380

Thanks they are very fiddley! They are all defected, is their a way I can check the four pin relay Is working like a normal relay?
Thanks again
by Wod
Fri May 15, 2015 4:09 pm
Forum: General and Support forum
Topic: 1.6 Tdci glowplug control circuit p0380
Replies: 5
Views: 6333

1.6 Tdci glowplug control circuit p0380

Hello there, another fault yet again lol. Does this mean my glow plugs need replacing? It says Above maximum threshold? I only see three relays in the engine all of which iv cleaned out. The wiring loom is the newer type and is not damaged. The car starts and drives but the ecu is leaving me in limp...
by Wod
Thu Apr 30, 2015 6:39 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Lumpy tick over no DTC
Replies: 0
Views: 2581

Lumpy tick over no DTC

The car in question is a 1.6 Tdci 90 fiesta,
Is there a way I can check that the injectors are operating correctly?
Also what is the normal flow rate for the MAF sensor at idle so I can test this ?
Thank you
by Wod
Sun Feb 15, 2015 11:35 am
Forum: Diagnostics and Maintenance using FORScan
Topic: Can i check turbo pressure and torque?
Replies: 5
Views: 6893

Re: Can i check turbo pressure and torque?

VGTDC Variable Geometry Turbo
Sits at 50%
So is this simply showing me the position of the boost control solenoid?
by Wod
Tue Feb 10, 2015 7:04 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Can i check turbo pressure and torque?
Replies: 5
Views: 6893

Re: Can i check turbo pressure and torque?

Hello there, is there an option to calculate torque output in NM? If there is no PID that shows it, then no. Different models support different PIDs, some have torque one, and some are not.... If i want to check my boost do i use the inlet pressure and subtract 1 bar? Yes, if there is no special PI...
by Wod
Mon Feb 09, 2015 7:55 pm
Forum: Diagnostics and Maintenance using FORScan
Topic: Can i check turbo pressure and torque?
Replies: 5
Views: 6893

Can i check turbo pressure and torque?

Hello there, is there an option to calculate torque output in NM? If i want to check my boost do i use the inlet pressure and subtract 1 bar? My car does not have VNT however i can see vnt %, is this just the percentage of the boost control solenoid? Does 100% =full boost or should 0%=full boost? Th...