FORScan forum

Same exact issue as MarcoGaspar... Reading block 5 failed on a 07 Mondeo 2.0 TDCI, guys correct me if i`m wrong... do you need to load SBL to read the CCF form BCM? i dont think so.. you can read it by pid just send "22F105" read 512bytes from "0x00FF8000 to 0x00FF81FF" than afte...

Just to name 2 OBDLink MX, ELS27 but there are many others, just look around for Forscan compatible devices and look for no togle and CAN MS support thats what you need...

Hi, i`m not sure about fueling curves or timeing as most of the time they are part of the PCM (engine management module) programming, thats what tunners tweek to come up with different "maps" for cars.. but some i dont know for sure if its doable with forscan as i`m new here as well but i ...

Perfectly normal, during a complex procedure you will need to swap form one CAN network to other (High-Low) the toggle is just a cost cutting thing.. other manufatures have autoswitching components that does that automatically...

Hello pragmatic, a simple answer would be that the 2009 Ranger is a CAN car and your ELM`s CAN pair work OK and the 2000 Lincoln is older than CAN protocol and has K and L line.. which means that your ELM`s K and L line might not work, try to hook it up to anything before 2005ish and if you cant get...

Hi, keefShure EEPROM is usually done on a bench as its a direct HW erase and flash procedure and i highly doubt that it can be done via OBD thats why its a "bench" job
Cheers