FORScan forum

I have a 2011 F350, 6.7 Powerstroke, 6R140, that I swapped out the transmission last week. I tried using Forscan to change the solenoid strategy and having issues. I went into the TCM and found where to change the strategy but as I change the number I then get an error that the strategy cannot be f...

It'll be great if they can find a way to disable it. Please update with the outcome

I have been struggling with this same issue. I am currently running Forscan 2.4.8 beta with a vLinker. I have no PCM Configuration(Plain Text) option available. I went back and downloaded and installed multiple older versions of Forscan but I still cannot get PCM Configuration to populate in the pr...

Firstly, update the vLinker https://forscan.org/forum/viewtopic.php?p=91022#p91022 Delete the profile & establish a new connection to the vehicle & see if the PCM calibration shows - I'm not familiar with this vehicle but it could be that it still needs a calibration added, if it's a fresh P...

Still haven't received it? Sounds like you might have used the wrong email address & it's gone to someone else. To get help, you should be going back to the payment page where you entered the details & provided payment. If you've done that, you may have to buy it again. There are 2 options ...

HI sorry about late reply .2.56 seems to work on all the 2023,s I have connected to it does take a while .to load and ask to toggle my switch to ms can then back to hs can .if I get a chance tomorrow I will grab a 2023 f150 .and try to connect .I am running the old real elm327 with the switch .and ...

I just downloaded V2.4.8 Beta anyone try this for TCM reprograming yet? How would I find out What and Which software is in the TCM I have? I'm a newbe so anyhelp would be appreciated! The TCM is new only the active learning was done. When you are on the "Vehicle configuration & interface&q...

Yes, I'm starting a new thread. Different question. I did find PCM VID block configuration, and where to change tire size. But when I want to make the VID block change, I get a message that this data is in the firmware and requires a firmware update. I just need to be clear on this step. Is Forscan...

Hyperflash is a result of there being near zero load on the circuit. The module doesn't give an instruction to start hyperflash.
Increase the load by refitting globes or adding a resistor.

colin39 wrote: ↑

Sun Sep 17, 2023 3:58 pm

I updated the free for 2months and then paid for the 12months but I have had no licence update come through any ideas please

Check your spam & junk folders. Make sure you didn't use an email address on the Blacklist

https://forscan.org/forum/viewtopic.php?f=5&t=13941