FORScan forum

My F-150 has an "Engineering Test Mode" that has an adjustable miles-to-empty weigh factor. It's not done using forscan though, so searching on some Focus forums would be your best bet to find the procedure for your car. Edit: It looks like your car calls it "HEC Dealer Test Mode" and it doesn't hav...

Look under "Service Functions". Wrench icon on the left.

It's not in Programming. Click the wrench icon on the left for Service Functions. Should be there.

Changing just the 2nd digit to 7 only works if you are starting with the US code of 5553. Change all 4 to 5753 and it should work.

Missing the www. Try this:

https://www.motorcraftservice.com/asbuilt

Look in FCDIM. This value is known to work in some vehicles:

7A5-01-01 x0xx xxxx xxxx Reverse camera disabled
7A5-01-01 x2xx xxxx xxxx Reverse camera enabled

It's most likely possible. Here is one of the most complete spreadsheets out there. It's for F-150 but the Sync3 stuff carries over: https://docs.google.com/spreadsheets/d/1uDSQ1Z5a2Wt8-kjrSiVSlDFGFHnfeuhb3RTMVz95730 Go to the APIM tab. Looks like 7D0-02-02 xxxx x*xx xxxx has the aux camera changes.

This may seem obvious but did you check that the new key has a good battery? The PATS chip would still work without a battery installed.

Try this:

https://docs.google.com/spreadsheets/d/ ... H9eM_Bhol8

Looks like you want to set 726-11-01 xxx* xxxx xx to 2 for Fog Lamps Present to be "enabled with high beams".

Both Sync2 and Sync3 use the same location for the country code: 1st 4 digits of 7D0-02-01. Changing it to 5753 will enable navigation in motion.