Modifying PCM As built to enable Cruise Control on Crown Vic

Share your FORScan experience with other users
Post Reply
Dr.Godzilla
Posts: 1
Joined: Wed Jul 12, 2017 1:18 am
Vehicle: Ford Crown Victoria

Modifying PCM As built to enable Cruise Control on Crown Vic

Post by Dr.Godzilla » Sat Sep 02, 2017 7:37 pm

Hey all,

First post here and I was wondering if there is a way to modify PCM As built to enable cruise control on a Crown Victoria. I was following a thread on crownvic.net where a member figured out which value to change but the software would not allow him to do it. http://www.crownvic.net/ubbthreads/ubbt ... 745&page=3. Any input would be greatly appreciated.

jrehus
Posts: 1
Joined: Wed Jun 13, 2018 12:53 am
Vehicle: Crown Victoria, 4.6 OHC V8, 2008

Re: Modifying PCM As built to enable Cruise Control on Crown

Post by jrehus » Wed Jun 13, 2018 2:13 am

Anyone have any luck?

ThatOneDude
Posts: 76
Joined: Fri Jul 07, 2017 12:46 pm
Vehicle: 2007 Ford F-150 SuperCab 5.4L 3V 4WD

Re: Modifying PCM As built to enable Cruise Control on Crown

Post by ThatOneDude » Fri Jun 15, 2018 5:36 am

To make any changes to the PCM, you'll need IDS and a VCM. FORScan does not make changes to the PCM.
1996 Lincoln Town Car Executive
2003 Ford Crown Victoria Police Interceptor
2007 Ford F-150 SuperCab 5.4L 3V 4WD
2011 Ford Crown Victoria Police Interceptor

Post Reply