Kvaser J2534 CAN-bus interface

Discussion about adapters and connections - usage, problems, solutions

Kvaser J2534 CAN-bus interface

Postby Pietermans » Tue Nov 14, 2017 12:04 pm

Hello,

I am new to this forum & to Forscan.

I own a Kvaser Leaf Light CAN-bus interface and I was wondering if this interface is supported by Forscan.
If you install the drivers of this interface you also have the possibility to install J2534 drivers. Does this mean it will work?!

Many thansk for any reply.

Regards
Pieter
Pietermans
 
Posts: 2
Joined: Sun Nov 12, 2017 8:45 pm
Vehicle: Fiesta mk7

Re: Kvaser J2534 CAN-bus interface

Postby Pietermans » Thu Nov 16, 2017 7:47 pm

sorry for my first question, I did not install the program at that time.
after installing it today I noticed that you can select the Kvaser J2534 hardware, at the moment I cannot yet connect to the car as I have to make the J1962 cable.

Only question I do have is; how do you select between HS CAN & MS CAN? or can you use a 2channel Kvaser device? connect HS CAN to channel 1 and MS CAN to channel 2?

Who can help me with this question??
Pietermans
 
Posts: 2
Joined: Sun Nov 12, 2017 8:45 pm
Vehicle: Fiesta mk7

Re: Kvaser J2534 CAN-bus interface

Postby autotrans » Sat Nov 18, 2017 1:39 pm

The obd connectors use pin 6 hi and pin 14 lo for HS CAN 500k
pin 3 hi and pin 11 lo for MS CAN 250k
never used the kvaser interface, but normally there is a dropdown menu
in the software to choose the data rate.
autotrans
 
Posts: 10
Joined: Sun Sep 18, 2016 6:49 am
Vehicle: HONDA VTEC 1600 2003


Return to Adapters & Connection

Who is online

Users browsing this forum: No registered users and 2 guests