Where to buy a compatible adapter?

Discussion about adapters and connections - usage, problems, solutions

Re: Where to buy a compatible adapter?

Postby Bjessop13 » Mon Sep 11, 2017 12:47 am

Bjessop13
 
Posts: 4
Joined: Mon Sep 11, 2017 12:39 am
Vehicle: Ford mustang 2001

Re: Where to buy a compatible adapter?

Postby Blackhawk2012 » Sun Sep 17, 2017 2:30 pm

I have a 99.5 E350 van and bought kobra elm327 wifi from amazon and it does not work. I have iPhone and android. I can see obd2 but it will not connect. Used a free app for testing and it says weak signal, it will connect but not show anything. When I start van and hit diagnosis it will kill engine. Any recommendations?

Thanks
Blackhawk2012
 
Posts: 2
Joined: Sat Sep 16, 2017 3:14 pm
Vehicle: 1999 ford E350 7.3 Powerstroke Econoline

Re: Where to buy a compatible adapter?

Postby Bjessop13 » Sun Sep 24, 2017 10:11 pm

I have tried these cheap scanners from amazon before and had nothing but issues.....if I were you I would honestly just get a scanner that is decent to begin with check out http://www.fuelsavingguys.net they have a good selection
Bjessop13
 
Posts: 4
Joined: Mon Sep 11, 2017 12:39 am
Vehicle: Ford mustang 2001

Re: Where to buy a compatible adapter?

Postby ThatOneDude » Mon Sep 25, 2017 1:18 am

Whatever you buy, make sure it specifically says it works with the Medium Speed Controller Area Network (MS-CAN) Bus for full support. I personally use the OBDLink MX Bluetooth.
1996 Lincoln Town Car Executive
2003 Ford Crown Victoria Police Interceptor
2007 Ford F-150 SuperCab 5.4L 3V 4WD
2011 Ford Crown Victoria Police Interceptor
ThatOneDude
 
Posts: 39
Joined: Fri Jul 07, 2017 12:46 pm
Vehicle: 2007 Ford F-150 SuperCab 5.4L 3V 4WD

Re: Where to buy a compatible adapter?

Postby RickyBobby » Wed Oct 18, 2017 8:37 pm

Also made the mistake of purchasing a cheap, $5., chinese ELM327 clone from eBay to use with FORScan and my 2014 Ford Escape. It has V1.5A on the label but uses an old Prolific PL-2303 chip. It may load the adapter in Windows 7 with the old drivers but not in Windows 10 that uses newer drivers. When you connect the adapter and check device manager you will see a yellow exclamation point next to Prolific USB-to-serial Comm port. You have to downgrade the driver to an earlier version. You can get the older driver from here: http://www.totalcardiagnostics.com/support/Knowledgebase/Article/View/1/0/how-to-install-elm327-usb-cable-on-windows-and-obd2-software In step 1 choose Windows 8, 10 and download Driver Pack 5. After installing the older driver FORScan saw the adapter on COM 3 but when I hooked it up to my Escape, key and/or engine on, I got the dreaded "Unable to connect to vehicle. Please make sure the ignition key is ON and try again". I contacted the ebay vendor, expecting to be blown off, but he was kind enough to refund me the 5 bucks. It may work with another vehicle but not with a newer Ford Escape.
Another cheap chinese ELM327 clone.
https://imgur.com/Bzmanrw

I was going to go with Scantool's $80. OBDLink MX adapter but on the Escape forum someone posted that this adapter also works with the newer Ford Escapes and FORScan. https://www.amazon.com/OHP-ELMconfig-compatible-interface-diagnostics/dp/B01F0GVBWY/ref=sr_1_1?s=automotive&ie=UTF8&qid=1508358477&sr=1-1&keywords=OHP+Ford+ELMconfig+USB+device+500kbit%2Fs+ELM327+compatible+interface+with+MS-CAN+switch+for+Forscan+FoCCCus+Mazda+OBD2+diagnostics

I also found this adapter that's cheaper than the OHP and uses the exact same FTDI chipsets. https://www.amazon.com/bbfly-BF32301-ELM327-V1-5-Diagnostic-Scanner/dp/B01N22B3FQ/ref=sr_1_fkmr3_2?s=automotive&ie=UTF8&qid=1508358587&sr=1-2-fkmr3&keywords=USB+Modified+ELM327+for+Ford+ELMconfig+Compatible+Interface+with+MS-CAN%2FHS-CAN+Switch

https://www.aliexpress.com/store/product/bbfly-ELM327-USB-modified-FTDI-chip-OBD2-Forscan-ELMconfig-HS-CAN-MS-CAN-OBD/2672184_32790698242.html

FTDI updated Windows' drivers: http://www.ftdichip.com/Drivers/VCP.htm

So I'm going to give the bbfly-BF32301 adapter a try and will report back with the results.
RickyBobby
 
Posts: 2
Joined: Tue Oct 17, 2017 1:22 pm
Vehicle: 2014 Ford Escape SE 2.0L

Re: Where to buy a compatible adapter?

Postby Ronald53 » Sun Oct 22, 2017 1:11 pm

This one definitely is s*h*i*t, it does not connect to FORScan Lite : https://www.aliexpress.com/item/Mini-EL ... 0.0.2iC4VK

And this one does connect! https://www.aliexpress.com/item/Vgate-i ... 0.0.vltvFx

The app ELM327 Identifier displays 100% compatibility with protocols 1.0 - 1.4 and 0% compatibility with 1.4b - 2.2.

Ronald
Ronald53
 
Posts: 1
Joined: Sat Sep 23, 2017 10:27 am
Vehicle: Transit Mk7, 2012, 125hp, EuroV

Re: Where to buy a compatible adapter?

Postby ghades » Tue Oct 24, 2017 5:25 pm

Hello
hey guys I just bought this adapter from ebay https://www.ebay.com/itm/New-ELS27-FORS ... SwC~tZjXTz
how do I know if its good adapter or not so far the only thing I've done is connected to my truck read everything ok with no problems just asking before I do any changes to my truck
ghades
 
Posts: 1
Joined: Sun Oct 01, 2017 3:00 am
Vehicle: ford f150 xlt blk 2015

Re: Where to buy a compatible adapter?

Postby RickyBobby » Sun Oct 29, 2017 2:08 am

Ordered the bbfly-BF32302 from AliExpress for $17.55 shipped. https://www.aliexpress.com/store/product/bbfly-ELM327-USB-modified-FTDI-chip-OBD2-Forscan-ELMconfig-HS-CAN-MS-CAN-OBD/2672184_32790698242.html Delivery time was 12 days. A little bit cheaper than Amazon and no sales tax. It also comes in a blue tooth version for a few bucks more.
The USB cable (6' long) version works great with my HP 10" tablet running Win 10 Pro 64 bit V.1709, ForScan, and my 2014 Ford Escape. No need to purchase the $80. OBDLink MX. I didn't see any conflicts in Device Manager when I plugged it into my tablet but to be current I downloaded and installed the latest FTDI chip driver. http://www.ftdichip.com/Drivers/VCP.htm Only con is there are no markings on the switch for what protocol you are in. MS Can is the left position and HS Can is the right. ForScan will tell you to flip it if it is on the wrong setting.
RickyBobby
 
Posts: 2
Joined: Tue Oct 17, 2017 1:22 pm
Vehicle: 2014 Ford Escape SE 2.0L

Previous

Return to Adapters & Connection

Who is online

Users browsing this forum: No registered users and 3 guests